Which Pixhawk version is this?

Pixhawk
1

Untitled
Untitled757×1600 133 KB

Untitled
Untitled757×1600 67.1 KB

Untitled
Untitled1600×757 105 KB

Untitled
Untitled757×1600 84.2 KB

Which Pixhawk version is this? Looking up on the internet, I was either unable to find proper information on it or I’m bad at googling drone stuff. The manual that comes with it just leads to the front page of pix.rctoysky.com

Untitled
Untitled720×1520 70.4 KB

It uses JST-GH connectors and I believe Pixhawk 4 uses them so this is somewhat similar?

Also I have hardware that uses the Molex Picoblade connector like any other Pixhawk. Can I replace them with JST-GH connectors for this?

Thanks

2

I regret to inform you this is not an original Pixhawk, you might want to reach out to the manufacturer for support. However it looks to be based on the FMUv2 open hardware.

3

Yes I figured that might be the case. That’s what you get for 28k PKR in Pakistan lol. Do you know which known board would this most closely correspond to in terms of features?

Those JST GH connectors have been a nightmare. I had to order a set of connectors so that I could go around cutting off the other connectors and placing these on all my components

4

It’s supposed to be a FMUv2 based flight controller Pixhawk Series | PX4 Guide (main)

1 Like