Going through my first setup with QGC and have most parameters accepted. Now attempting to test motors and getting: Motor test command not supported. Running new Holybro Pixhawk 4 kit. QGC firmware: V1.10.1 Any thoughts, thanks in advance…

Motor test command not supported

ChrisDaily May 4, 2020, 12:44pm 4

Generic hexarotor x geometry the drone is a hex Tarot 680 with Pichawk 4

Topic		Replies	Views
Motor command not supported PX4 Autopilot	3	1965	April 7, 2020
Problems with ESC's (s500 v2 kit) QGroundControl	2	358	June 4, 2020
Motor Test Command Denied Using QGroundControl	21	13422	July 15, 2021
Just getting started, no Motor setup option Using QGroundControl	2	772	February 2, 2020
S500 / PixHawk 4 / px4: New build does not start PX4 Autopilot	7	1064	May 29, 2021