Hi all. I have a Frsky RX8R receiver and Taranis QX7 hardware. I purchased a special cable for signal conversion, and in PX4 firmware, on QGroundControl configured the telemetry port Frsky (TEL_FRSKY_CONFIG = 102: TELEM 2) in accordance with the cable connector on the pixhawk 4 clone flight contr…

Hi Can you provide the output of frsky_telemetry status on the shell?

Hi, I am using a Taranis X9D and R-XSR Receiver with a Pixhawk 4 and my Taranis can’t detect the sensors either. According to Redirecting to latest version of document (main) I should be able to directly connect Receiver S.Port to Telem2 TX [20210518_124704] frsky_telemetry status reports: runn…

Update: I got it to work, the problem was, that the R-XSR uses the F.Port protocol on the S.Port Pin by default, when it is flashed with the Access firmware (2.1.7 in my case: https://www.frsky-rc.com/r-xsr/ ) To change this, you have to manually set the output to S.port with the radio, as describe…

Frsky telemetry sensors

PX4 Autopilot

rollys July 20, 2020, 12:17pm 3

Your cable only works for ArduPilot. You need to use a Teensy. Here’s a step-by-step.

Good luck.

Topic		Replies	Views
Pixracer R14 FrSky X4RSB Taranis X9D+ Telemetry not Working PX4 Autopilot	4	1036	August 17, 2018
Telemetry cable for Pixhawk1 and Frsky / Taranis	4	1705	March 30, 2019
Pixhawk 5x - FrSky Telemetry ID Reference List? Pixhawk	2	795	May 11, 2023
[Question] Pixracer - FrSky Telemetry S.Port - How to connect? PX4 Autopilot	4	3526	December 30, 2017
Displaying flight info on Radio?	2	842	December 10, 2018

Frsky telemetry sensors

Related topics