Is there a y3 type VTOL model

The Convergence might fit the bill. Good luck.

Thank you for your blessing! Actually, I have built a y3 tilting rotor, which runs apm firmware. I want to replace a set of can equipment, but it is impossible to automatically assign ID to esc in apm firmware.Below is my plane’s video link。

If you are looking for tricopter setup refer to my post here [image] VTOL with Tricopter setup VTOL 🚁 Hello everyone, I decided to build a VTOL with EDFs on flying wing with tricopter style as described below image [image] I actually almost finished building as below …

The problem I have now is that apm’s firmware cannot assign an ID to can esc

did you ever figure this out? I’m going to try pretty much the same thing, and I had considered CAN ESCs just for fun. If necessary I can make a way to set the CAN ID for a motor.

VTOL y3🙃 =

PX4 Autopilot

Kyuhyong_You September 19, 2018, 9:31am 5

If you are looking for tricopter setup refer to my post here

Topic		Replies	Views
Tricopter Y and VTOL Tiltrotor conversion PX4 Autopilot	2	1467	November 8, 2020
VTOL Tri-Copter Torque balance mechanism PX4 Autopilot	11	10427	October 26, 2017
VTOL with Tricopter setup PX4 Autopilot	18	8254	March 12, 2021
Y3 type + 3 prop tilting PX4 Autopilot	5	1956	July 7, 2017
VTOL tilt bi-rotor (OV-22 osprey like) PX4 Autopilot	3	624	July 19, 2022

VTOL y3🙃 =

Related topics