Using the connection UDP on port 14551, the QgroundControl remain disconnected from the Pixhawk 6x when using the h16 (30Km receiver), but using the Sik radio all is OK. When oppening the QgroundControl app. the error is : "Error binding the UDP port: The bound address is already in use " I use p…

If you have binded the air unit and handheld and following the instructions it should work fine. The udp port number for uart 0 is 14551 make sure to connect it to the correct uart port. If you still have issues then reply here

Yes I configured port and and insert cable to uart0 of the receiver as you say the problem remain. But trying to solve something, I start a firmware update from H16Tool /Advanced settings, this update work since 2hours and didn’t stop, even if I stop the Skydroid tablet, the update doesn’t finish e…

I solved the problem with Firmware update in H16Tool app, and now the Skydroid H 16 work Ok, but If someone can tell me what firmware was updated from v1.2 to v1.3, the only information that I find H16Tool is : “Local firmware”.

The connection problem remain, when start the QGC I receive the error: "Error binding the UDP port: The bound address is already in use ".

Well the new pro units also had asked for firmware update I did them with no problem. But their technical support sucks, I can’t reach them anyway. A bit dumb question but do you manually choose to connect on the qgc comm links tab? the message you get is usual and doesn’t cause any problems for me

Yes I do the connection from Connect button from Comm Links but QGC remain Disconnected. Did you check/uncheck the UDP check box in ApplicationSettings/General menu?

I am not sure, but that shouldn’t cause any problems. This seems weird, can you post some pictures and screenshots from your setup?

Sure, but I’ll send you these pictures Monday, I have some family health problems now. Thank you !

I also have the same problem: Skydroid H16 does not transmit complete measurement data. What is the solution?

Skydroid 16H Pro can't connect through receiver h16 to Pixhawk 6x

Pixhawk

Vacoff February 21, 2024, 9:14am 15

Good that you located the problem. If you get anything back from them please reply here so I would know if I also should wait for response or not.

Topic		Replies	Views
QGroundcontrol "Detected 0 radio channels. To operate PX4 you need at least 5 channels" Using QGroundControl	39	16185	November 17, 2023
QGC not getting Transmitter (Controller) signal Using QGroundControl	3	2617	April 16, 2021
QGroundControl: How to Spektrum Bind when connected to Pixhawk Using QGroundControl	28	9616	October 8, 2018
Px4 FrSky Telemetry Setup with Pixhawk2 and X8R Receiver PX4 Autopilot	18	13936	May 12, 2019
Motor Test Command Denied Using QGroundControl	21	14568	July 15, 2021

Skydroid 16H Pro can't connect through receiver h16 to Pixhawk 6x

Related topics