Pixhawk on a Matrice 100

1

Hello all, I would like to know if it is possible to install the Pixhawk system on to a Matrice 100?

I have a Sony WX500 30X zoom camera on a 3 axess gimbal that until recently was connected through a DJI N1 video encoder, which as now gone end of life and no longer supported by DJI.

Because I can no longer use this camera for passing the video output to the DJI GO app, on the DJI remote controller, I am looking to upgrade my remote control system if possible.

2

I confirm it is possible and documented (somewhere I don’t remember), we did it (Pixhawk 5 on a Matrice 100).

There is even a pre-configured set of parameters that made it fly on the first try, control loops properly tuned and all :ok_hand:

3

Hello Thomas,

Thanks for getting back to my query. It’s a pity that you don’t have a link to the documentation, but at least I now know that it is possible to do.

My problem is that DJI has withdrawn support for the N1 video encoder, so I can no longer get video on the DJI GO app.