Hello,
I am building a Skyhunter VTOL plane and having trouble setting up the PX4 with PM07 board. I cannot find any documentation can someone point me in the right direction???
If i connect the PX4 to Ardupilot and check in the setup page the remote controller I can see that the remote / receiver is connected. If I check the servo output page servo movement si correct in Q mode and FBW mode. However when the model is powered there is no servo movement and motor response is not correct.
I connected the PX4 I/O PWM out to the PM07 I/O PWM in port and the PX4 FMU/PWM out to the FMU-PWM in port on the PM07…