I want to upgrade some of my hexacopters from Pixhawk 1 to the Pixhawk 4. According to what I read, Holybro worked with Auterion to optimize this hardware version for PX4 flight stack. That’s good news. The bad news is that this hardware is missing the all important servo connector block that exists on all other Pixhawk models! How am I supposed to connect the 6 ESC servo connectors to the controller? I know that Holybro makes a breakout power distribution board, but this board requires you to solder the servo signal wire to the board. Are they crazy? I am not going to cut perfectly good servo connectors off of the ESC’s and solder them to a board. Can’t they at least provide a cable that goes from the I/O PWM OUT to a servo connector block? That would make a lot more sense.
Am I missing something here?
Joe
PS; this is what I am looking for.
