FrSky FLVSS sensor data transfer to Pixhawk

[Mike_S]

Hi,

there is the possibility with z. B. a Teensy to transmit the data from the flight controller via the SmartPort of a FrSky receiver to the transmitter.

Is there also a possibility to use the Lipo Sensor FLVSS from FrSky via z. B. to connect a Teensy or Arduino Nano to a Pixhawk to transfer the voltage of the flight battery to the flight controller?

If that works, I would like to connect the FLVSS to the Pixhawk / Dropix as a voltage sensor.

Is anyone able to help me?

Thanks and Greetings
Mike

[jimdgit]

there is the possibility with z. B. a Teensy to transmit the data from the flight controller via the SmartPort
of a FrSky receiver to the transmitter.
Yes but you don’t need a teensy to get the PX4 telem to the TX. PX4 can talk SmartPort. You need an inverter cable that connects between the RX and the FC. This will send telemetry to you Tx. It’s call a FrSky Yaapu Telemetry Converter Cable Pixhawk to Taranis and connects from the telem 2 port. Then add the sensors on the TX and then will see the telem on the TX. You can get them from amazon or bangood.
If you want the PX4 to see the SmartPort data and use it you will have to figure that out. It can read the data but I am not sure if it looks at it and sends it to QGC. All the tennsy code was to get the telem to the Frsky tx before PX4 could talk SmartPort.