Hello, I need help) My first steps in PX4. 2 days try to make servo working on AUX1 or AUX2. [image] I put a servo on RC10/AUX2, on taranis I set on the channel 6 variometr, but its not working. Arming\disarming\safety switch - not working. What I do wrong? Thanks.

Name: Auxillary device setup on a Px4 -QGC - Herelink Telemetry
Uploaded: 2023-05-12T15:09:13Z
Description: Yes, mine works perfectly fine . I run on a CUBE Orange . Video for the settings as per link below. [Auxillary device setup on a Px4 -QGC - Herelink Telemetry]

Which autopilot do you have and where did you connect the servo?

Take a look at the mixing documentation here. https://dev.px4.io/en/concept/mixing.html Depending on your autopilot and airframe chosen you should have a passthru mixer on the AUX outputs. [image]

[image] i put servo to RC10 = aux 2 am I wrong?

That top APM Copter label is only relevant for that firmware. Look at the manual passthrough documentation I posted above. Passthrough AUX1 input defaults to AUX6 output.

Hi I have a similar problem right now. I’m using v1.10.1 of px4, and I’m using the basic pixhawk board. I modifed the mixer for a tricopter such that I have the 3 motors on MAIN1, MAIN2, MAIN3 respectively, and the 3 servos on AUX1, AUX2, AUX3 respectively. Thus, I have two mixer files one for the M…

Were you able to resolve this issue

have u solved？i have same question now

Yes, mine works perfectly fine . I run on a CUBE Orange . Video for the settings as per link below. [Auxillary device setup on a Px4 -QGC - Herelink Telemetry]

thanks，i have solved my problem，if others want to add a servo in px4，remeber to provide a bec for px4,just insert in any aux output

AUX Passthrough. How?

PX4 Autopilot

sibujacob May 12, 2023, 3:09pm 9

Yes, mine works perfectly fine . I run on a CUBE Orange . Video for the settings as per link below.

Topic		Replies	Views
Failed to link AUX passthrough to FMU PWM OUT port of PIXHAWK 4	2	832	June 9, 2023
PixHawk Mini with S-Bus Rx and Taranis Tx PX4 Autopilot	4	593	September 5, 2018
How to control servo on AUX1 port of PX4(via code - not RC) PX4 Autopilot	2	1143	June 27, 2023
Example configuration with passthrough mixing for gimbal control PX4 Autopilot	4	4309	June 19, 2016
[solved] Pixracer and AUX RC Passthrough for gimbal setup PX4 Autopilot	1	773	March 24, 2021

AUX Passthrough. How?

Related topics