I have connected the px4 to pm07 board and also connected 1 servo on FMU-PWM-out 1 pin of PM boar to check if it is working or not. But i can not control it from RC. I used oscilloscope but there is no signal on this pin. But the Futaba receiver shows signal on channel 1 when i move the joystick

Pixhwak 4 PM07 board no signal control of servo using RC

Jaeyoung-Lim September 9, 2021, 1:29pm 2

Topic		Replies	Views
Pixhwak 4 with PM07 board no control for servo using RC PX4 Autopilot	4	863	September 10, 2021
Pixhawk 4 and PM07 connection PX4 Autopilot	0	40	July 18, 2024
Servo not working PX4 Autopilot	1	613	June 16, 2023
Communication between Pixhawk 4 flight controller and Holybro PM07 Power Distribution Board Pixhawk	0	319	October 22, 2021
No output from servo rail rc1-4	2	885	February 8, 2017