Pixhawk 4 Power Management Board

Hello! I have a general question regarding HW - specifically power from the battery. I’m trying to see if I can use a LiPo 3600mAh 100C battery from YoWoo, but I’m having no luck finding any answers. The PM Board has 12awg power wires, but my battery has 10awg wires for connection. If I’m correct, that’s 360A that would be pulling through the PMB, which (from what I read) is rated for 60A and 120A for the current sensor. Any advice?? (My issue can be found here in the px4.slack.com forum: https://px4.slack.com/archives/C0W2KUFFT/p1562891701329600)