Pixhawk 4, Power Management Board Max current

Hello every body. Hope you are all doing well.

I am going to start a project (rover) with the help of Pixhawk 4 and its new configured PMB. it has been mentioned that this board is capable of conducting a current of 120 Amper magnitude.

My question is that can this current be passed through just one of the motors or it is the sume of all motors consumption which can reach to 120 amps.

I have this question since my rover motor needs its current to be close to 100 ampers and if the predefined tracks on PMB board is not capable of conducting this amount of current, then I have to parallel all of them together in order to supply the required current to my motor.

would be so thankful if any of friends in here can help me.

looking forward to hearing from you