Calibration failed: reading sensor

PX4 Autopilot Configuration & Flight Modes ⚙️
1

Hi,
I am trying to do the calibration for compass.
I have PX4 installed on a Raspberry Pi 5 connected with Navio2.

When I try to do the calibration using QGroundControl, every time I get the same error, no matter what i try to do or change.

err
err1918×1080 197 KB

on left is what I see in QGC, right up is the PX4 running and the error I get in the loop and on the right down are the sensors I am using starting in px4.config on RPI.

If someone could help me with this issue please :slight_smile:

1 Like
2

I was able to solve this problem. Some files from Emlid navio2 were missing from my folders. after installing them and choosing the right sensor all calibrations worked just fine.