MATEK AIRSPEED ASPD-DLVR [UAVCAN] : Not working

PX4 Autopilot Drivers & Sensors 🔧
1

Hi everyone,

Hardware configuration : Cube Orange & Carrier board ADS-B, GPS HERE 3 (can1) and Airspeed sensor matek DLVR-L10D (can1)

Firmware : The last stable PX4 with standard plane Airframe.

When i tried to calibrate the airspeed sensor, i have an error message : “[cal] No airspeed sensor found”
In parameters, i see the airspeed sensor (Compoment 113).

I tried with arduplane V4.1.2, it works well.

Is it possible to use the airspeed sensor in UAVCAN with PX4?

Many Thanks.

2

Hello,

I have the same problem. Were you able to solve the problem? Could you tell me how?

Best regards, Tim

3

Hello,

I did not find a solution. If you want to use this airspeed in can mode, you wiil have to write the driver or use it in I2C mode.

Personally, I took the arduplane solution for the moment.