Spektreworks Kore Multirotor Carrier Board built-in power module

1

Hi !!!

Are some using the Spektreworks Kore Multirotor Carrier Board v1.3.1 board for CUBE with PX4 flightstack???
With arducopter no problems to set-up build-in power module and Batt settings
BATT_AMP_OFFSET 0.45
BATT_AMP_PERVOLT 50
BATT_CURR_PIN 3
BATT_MONITOR 4
BATT_VOLT_MULT 15.3
BATT_VOLT_PIN 2

But when I flash PX4 firmware, it doesn’t recognize power module like a sensor.
How to change these params?

1 Like
2

Did you ever get an answer to this?

1 Like