I have a Y6 copter with a new Pixhawk mini. Motor 5 keeps stopping - the pattern suggests a loose connection. I have swapped out the motor, ESC and reflashed with version 5 firmware. The problem persists. I am not confident that I will find the problem and of course there will be a trust issue. Is i…

goneXC, Have you had any luck remapping motor 5 to motor 7? I am curious if this is possible. Bests, Jordan

Remapping motor output

goldarte April 22, 2019, 2:14pm 3

The answer (one of the possible solutions) is here: Change motor layout for quad

Topic		Replies	Views
QGC / PX4 swapping motor outputs Using QGroundControl	0	1001	January 25, 2018
Swapping Motor Outputs in Software PX4 Autopilot	3	1514	April 22, 2019
Remap motor output PX4 Autopilot	2	1711	July 2, 2020
Change motor layout for quad	3	3469	April 22, 2019
New Pixhawk 4 Motor issues Pixhawk	2	774	November 7, 2019